Ovation-software Label Printer Manuel d'utilisateur télécharger pdf (Page 20)

Getting Started

12 Ovation2

The second label printed is the test pattern label. This label is used to

determine whether the printhead is in need of replacement. 'Good' and

'Bad' Test Pattern labels are shown below:

Good Test Label: Indicates

that the printhead is operating

normally.

Bad Test Label: Streaks in

test label indicate a dirty or

faulty printhead.

(See Chapter 3 for cleaning

and replacement.)

Figure 1-13 Printhead Test Label

1.11 Setting the Printer to the Factory Defaults

With the printer off, press and hold the feed button while turning the

printer on. Continue to hold the feed button for 60 seconds and then

release. The printer will now be set to the 'Factory Defaults', which

are shown in Table 1-1.

Function Value

Baud Rate 9600

Word Length 8 bits

Print Method direct thermal

Alternate Character Set standard

Cutter disabled

Paper Type gap

Table 1-1 Factory Default Settings

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 65 66

Pas de commentaire

Ovation-software Label Printer Manuel d'utilisateur Page 20